I am building up a Tamiya Leopard 2A6 full ops tank. page 17 shows placing 3 MR2 bearings in each of the 14 holes. The 2 on the outside of body are easy to install, but I cant get the inner one down far enough on the inside for placement. Any tricks to this ? I need help.
thanks
torsion bar bearings in a tamiya leopard 2A6
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
- Recruit
- Posts: 39
- Joined: Mon May 02, 2022 7:52 pm
-
- Recruit
- Posts: 39
- Joined: Mon May 02, 2022 7:52 pm
Re: torsion bar bearings in a tamiya leopard 2A6
no problem after all. I was thinking the inner bearing went up against the inner frame but it does not.