So I have recently bought two 360° metal turret rings for my heng long tigers and have run in to an issue. The metal ring doesn't sit right on the turret and, before I start trimming plastic I thought I would ask for help.
Now I was just wondering if I need to trim the ring on the bottom of the turret down to get this to fit or if it should have been a straight drop in part?
Metal turret ring on heng long tiger help.
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
- tankme
- Warrant Officer 1st Class
- Posts: 1982
- Joined: Tue Oct 31, 2017 3:51 pm
- Location: Elgin, TX
- Contact:
Re: Metal turret ring on heng long tiger help.
It's not a complete drop-in part as sections needs to be cut away to make space for the bearings. I have found that the metal ring dimensions are slightly different than the plastic ones from Heng Long and Taigen. Personally I would test fit the metal ring without the turret to see if the dimensions are good before modifying the turret to get it to fit.
Derek
Too many project builds to list...
Too many project builds to list...