Hi chaps..
Just treated myself to a shiney new king tiger with a 6.0s board.
I've fitted Flash units to all my other ranks but I have no experience with this board.
So, before I crack it open can someone advise me of best practice with the new system please.
Ta muchly
Rckt
Fitting taigen flash unit to heng long 6.0s edition
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
- Warrant Officer 1st Class
- Posts: 1665
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Fitting taigen flash unit to heng long 6.0s edition
Hello
This fahs is Led 1,the gun switch must be CN 6 ( Trigger ) which controls the flash
This fahs is Led 1,the gun switch must be CN 6 ( Trigger ) which controls the flash
Re: Fitting taigen flash unit to heng long 6.0s edition
Hi and thanks for the reply.
So, do you recommend just wiring an led into that port?
The Taigen flash unit has a two pin and a five pin unit. Can that be used just omitting the five pin?
And lastly you mention the trigger line. What do you do with that?
And thankyou in advance!
So, do you recommend just wiring an led into that port?
The Taigen flash unit has a two pin and a five pin unit. Can that be used just omitting the five pin?
And lastly you mention the trigger line. What do you do with that?
And thankyou in advance!
Re: Fitting taigen flash unit to heng long 6.0s edition
If its just xenon flash you want then you can do it this way
viewtopic.php?f=79&t=30525
but you will need to cut up the BB gun to get the flash down the barrel
viewtopic.php?f=79&t=30525
but you will need to cut up the BB gun to get the flash down the barrel
Re: Fitting taigen flash unit to heng long 6.0s edition
OK thanks. If I want to just wire an led in what voltage should I aim for?