I see these 4 screws and washers plus what I assume are 2 bearing provided with my sprocket/idler set I bought for my HL PZIII
Question is what exactly are they used for ? A different application? Seems too me these sprockets and idlers will go on using the original screws that held on the plastic sprockets etc.thats correct right,
Small screws with Taigen sprocket/idler set
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
Small screws with Taigen sprocket/idler set
But it’s a dry heat!
HL Panzer III
Taigen Tiger 1 Mid Metal edition
HL Panzer III
Taigen Tiger 1 Mid Metal edition
Re: Small screws with Taigen sprocket/idler set
Thx gunner,
I asked because I was curious seeing as some front sprockets are 2 pieces and I had seen some pictures where the outer and inner were screwed together.
Im assuming the front sprockets are both held together with the one hex head screw.
I asked because I was curious seeing as some front sprockets are 2 pieces and I had seen some pictures where the outer and inner were screwed together.
Im assuming the front sprockets are both held together with the one hex head screw.
But it’s a dry heat!
HL Panzer III
Taigen Tiger 1 Mid Metal edition
HL Panzer III
Taigen Tiger 1 Mid Metal edition
Re: Small screws with Taigen sprocket/idler set
Good to hear my thoughts confirmed,hope to finish painting them today.
But it’s a dry heat!
HL Panzer III
Taigen Tiger 1 Mid Metal edition
HL Panzer III
Taigen Tiger 1 Mid Metal edition