Small screws with Taigen sprocket/idler set

If you have a tank query and you can't find the answer anywhere else, post here. (TIP - Check for answers in FAQ, use the 'search' facility or even check this board before posting here).
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
Post Reply
User avatar
Ragnar
Corporal
Posts: 431
Joined: Thu May 10, 2018 5:45 pm
Location: Phoenix Az.

Small screws with Taigen sprocket/idler set

Post by Ragnar »

I see these 4 screws and washers plus what I assume are 2 bearing provided with my sprocket/idler set I bought for my HL PZIII
Question is what exactly are they used for ? A different application? Seems too me these sprockets and idlers will go on using the original screws that held on the plastic sprockets etc.thats correct right,
But it’s a dry heat!
HL Panzer III
Taigen Tiger 1 Mid Metal edition
User avatar
Ragnar
Corporal
Posts: 431
Joined: Thu May 10, 2018 5:45 pm
Location: Phoenix Az.

Re: Small screws with Taigen sprocket/idler set

Post by Ragnar »

Thx gunner,
I asked because I was curious seeing as some front sprockets are 2 pieces and I had seen some pictures where the outer and inner were screwed together.
Im assuming the front sprockets are both held together with the one hex head screw.
But it’s a dry heat!
HL Panzer III
Taigen Tiger 1 Mid Metal edition
User avatar
Ragnar
Corporal
Posts: 431
Joined: Thu May 10, 2018 5:45 pm
Location: Phoenix Az.

Re: Small screws with Taigen sprocket/idler set

Post by Ragnar »

Good to hear my thoughts confirmed,hope to finish painting them today.
But it’s a dry heat!
HL Panzer III
Taigen Tiger 1 Mid Metal edition
Post Reply

Return to “General Questions”