Taigen Panther F - internal layout

[bfrank1982]

Just kept the Stock motor and rewired it to fit the 9pin wire coming from top hull ( tap into the correct wires )

8p.jpg

OK. Since I dont know much about electronics.

Do you think it will possible to use a servo instead?

Sendt fra min HUAWEI VNS-L31 med Tapatalk

[maxmekker]

sure.

just need to find a clever way to attach it to the barrel . and plug the servo inti the elevation port of whatever Board you choose to run in the tank .

a recoil unit of the 'universal type also, might slip in With some work .

cfd6d82627466ea369b322947885a2d5.jpg (88.01 KiB) Viewed 1238 times

d6964d94d7b5bf773f68be1c7d0137ac.jpg (86.68 KiB) Viewed 1238 times

[c.rainford73]

sure.

just need to find a clever way to attach it to the barrel . and plug the servo inti the elevation port of whatever Board you choose to run in the tank .

a recoil unit of the 'universal type also, might slip in With some work .

cfd6d82627466ea369b322947885a2d5.jpg

d6964d94d7b5bf773f68be1c7d0137ac.jpg

This is the design I prefer too Stian

Sent from my 2PS64 using Tapatalk

[bfrank1982]

sure.

just need to find a clever way to attach it to the barrel . and plug the servo inti the elevation port of whatever Board you choose to run in the tank .

a recoil unit of the 'universal type also, might slip in With some work .

cfd6d82627466ea369b322947885a2d5.jpg

d6964d94d7b5bf773f68be1c7d0137ac.jpg

Nice.

If you could take some pictures of the elevation in finished and worling order order I would appriciate it very much

Sendt fra min HUAWEI VNS-L31 med Tapatalk

[maxmekker]

I kept the stock motor. just unsoldered all wires from the taigen recoil unit and rerute it to the right pins on the board ( in photo it was on the right pins on the 9 pin socket just for test)

ss (Small).jpg (93.36 KiB) Viewed 1219 times

phpBB [video]