Evening all
Can anybody tell me the correct connections for ibu2 pro to 6 channel reciever. Eg Chanel 1 on reciever goes to which channel on ibu2 board and so on. I can’t work out which order to put the 6 reciever wires onto the ibu board to have the tank operating as per the manual which is throttle and steering on right stick and turret functions on the left stick.
Any help would be appreciated
Thanks
Glyn
Ibu2 pro to reciever connections
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
Re: Ibu2 pro to reciever connections
Morning
Managed to work this one out this morning with a fresh pair of eyes. This might be useful information if anyone is setting up an ibu. The connections are as follows
Reciever ch1 to ibu ch2
Reciever ch2 to ibu ch1
Reciever ch3 to ibu ch3
Reciever ch4 to ibu ch4
So basically swapping channels 1 and 2 over
Channels 5 and 6 on my ibu are swapped over as well but that is only because I mapped the switch on my transmitter to channel 5 and the ibu uses Chanel 5 to start the engine
Hope this info is useful to someone
Glyn
Managed to work this one out this morning with a fresh pair of eyes. This might be useful information if anyone is setting up an ibu. The connections are as follows
Reciever ch1 to ibu ch2
Reciever ch2 to ibu ch1
Reciever ch3 to ibu ch3
Reciever ch4 to ibu ch4
So basically swapping channels 1 and 2 over
Channels 5 and 6 on my ibu are swapped over as well but that is only because I mapped the switch on my transmitter to channel 5 and the ibu uses Chanel 5 to start the engine
Hope this info is useful to someone
Glyn