 
  It would seem possible do switch the Radio Flysky FST 6 ( 6 chanels ),by upgrading the firmware,has anyone tried ? It is possible with an FSi 6 which seems to be the same as FST6 ? ? ?
 
   It only takes a slight difference in the cmos unit, or firmware chip's pathways, to create a 'new' model.
  It only takes a slight difference in the cmos unit, or firmware chip's pathways, to create a 'new' model. 
 
  no bigger
 no bigger Unlike our dear old TX-guru, Rad, I don't need more than 6 channels, normally.
  Unlike our dear old TX-guru, Rad, I don't need more than 6 channels, normally. 
  
 !!At the same time i will follow Rad's advicev,and find a Flysky TH9XB.Good Nigth
!!At the same time i will follow Rad's advicev,and find a Flysky TH9XB.Good Nigth 
Well, my advice in the past, was to get a 9X radio, flash the software and fit a new screen.Jofaur86 wrote:I will do thevtest ,found in the net that two RX were compatible with T6 ?an RB 6 ( 6 chanels ) RB 9 ( 9 chanels ) ??as well as the protocol!!At the same time i will follow Rad's advicev,and find a Flysky TH9XB.Good Nigth
 
 
9XR is a 9X with a newer horrible case.Jofaur86 wrote:Hello
Having sufficiently abused Rad's kindess,would know the dufférence between Turigny X9 an X9R ( V2 ) ? In advance thank you