A pic with all the actuators in place , forgive the dirt in the hull, it will be cleaned and painted when I am done
The motive power was going to be two cordless drill motors with their gearboxes. I had two of the same model but when I opened the drills up I found they had two different motors. The gearboxes seemed to have the same gear ratios albeit with slightly different designs. I was going to replace the motors so at least they were identical. One gearbox could not run without locking up. I abandoned them and found two motors with gearboxes on Aliexpress.
These motors and gearboxes are a little wide for the hull hence the long black tubes. These are right angled drill attachments for power tools with the drill chucks removed. I have machined two shafts that slip over the shaft in place of the chucks.
There will be plenty of space in the hull for batteries and the other gubbins .
1/10th Stridsvagn 103C
Re: 1/10th Stridsvagn 103C
Tiger 1
Mowag Piranha 3C
Stridsvagen 103C
Mowag Piranha 3C
Stridsvagen 103C
- Ecam
- Warrant Officer 2nd Class
- Posts: 1430
- Joined: Sun Jul 13, 2014 6:30 pm
- Location: Lake of the Ozarks, USA
Re: 1/10th Stridsvagn 103C
Now that's a creative gearbox! I'll guess the ratio in the drill head is about 3 to 1 what are the reduction units on the motors?
By the way, the pictures are just fine.
By the way, the pictures are just fine.
"Don't believe everything you see on the internet" - George S. Patton
Eric
Eric
- tankme
- Warrant Officer 1st Class
- Posts: 1995
- Joined: Tue Oct 31, 2017 3:51 pm
- Location: Elgin, TX
- Contact:
Re: 1/10th Stridsvagn 103C
Actually like the layout. Very nice. I was thinking of using similar motors for a project.
Derek
Too many project builds to list...
Too many project builds to list...
Re: 1/10th Stridsvagn 103C
The gear box out put is 1100 rpm @ 12v I have ordered a digital tachometer from eBay so I will see what the output at the drive sprocket will be.
Tiger 1
Mowag Piranha 3C
Stridsvagen 103C
Mowag Piranha 3C
Stridsvagen 103C
Re: 1/10th Stridsvagn 103C
Thank you,
I thought it might be a clumsy solution but it fits well under the upper hull. I could not find any suitable gear motors at the time . I did consider using metal gearboxes from 1/16th tanks but thought they would not be up to the job.
The upper and lower hull are 11kg at present with wheels and tracks yet to be added.
The pics below show the final drive axles that mount in place of the chuck. I could not use the thread used by the chuck, it’s a square profile. I don’t have any taps of that type. The final drive shafts will be fixed in place with a grub screw, they are a very snug fit . They cannot slide out of the hull. The whole right angled part needs to be removed and the shaft pulled internally.
I machined a mount to take a bearing to support the drive shaft as it exits the hull. This will be hidden behind the drive sprocket.
Paul
Tiger 1
Mowag Piranha 3C
Stridsvagen 103C
Mowag Piranha 3C
Stridsvagen 103C