TK60 non Sbus help

[68firebird]

Purchased a tk60 and flysky is16s and 10ch as per clark setup.bound tx to rx and plugged in ch1-8 as per instrutions.assiged chrysler 7and 8 to switches.set trims to centre 50%.nothing.please any suggestions.
Many thanks

[c.rainford73]

Purchased a tk60 and flysky is16s and 10ch as per clark setup.bound tx to rx and plugged in ch1-8 as per instrutions.assiged chrysler 7and 8 to switches.set trims to centre 50%.nothing.please any suggestions.
Many thanks

What's happening with your setup? More details please

[68firebird]

Turn on power and rx red light comes on.shift switches to start engine
No sound shift switch to engage clutch.no motion from motors. I don't have a volume knob connected to board and upper hull and smoker not connected.

[c.rainford73]

Turn on power and rx red light comes on.shift switches to start engine
No sound shift switch to engage clutch.no motion from motors. I don't have a volume knob connected to board and upper hull and smoker not connected.

You must have a volume knob for sound.

[68firebird]

Ok thanks I'll find a volume knob.does everything have to be plugged I to board or can you plug one item at a time.

[c.rainford73]

Ok thanks I'll find a volume knob.does everything have to be plugged I to board or can you plug one item at a time.

Not necessarily, but the primary connections like power, speaker and volume pot need to be connected. Or all at one time. Hope this helps.

[maxmekker]

Purchased a tk60 and flysky is16s and 10ch as per clark setup.bound tx to rx and plugged in ch1-8 as per instrutions.assiged chrysler 7and 8 to switches.set trims to centre 50%.nothing.please any suggestions.
Many thanks

did you get any info on how to setup/ program the radio etch upon purchace ?

dont forget to put a jumper in the SW port

this might help you

phpBB [video]

[68firebird]

I've put a jumper in the switch port.power is supplied from main battery on off.

[maxmekker]

Any progress ?

[68firebird]

I've watched the video and have had some success as in I now have some sound and forward and reverse.have not fitted the top deck and turrett.the rotary dials do what there supposed to do and switches B and C kind of do what there supposed to do as in STOP start and neutral and I can rev the motor.when I engage gear I only have forward and reverse.in the video it says assign channels 5&6.but on the clark website for non s bus these rant used on the 10ch rx.ive plugged into the rx chrysler 1to4 and 789and10
Any idea as please