Hello all,
I have a Torro King Tiger and the smoke unit was broken, I've bought a replacement and fitted it, but it doesn't work.
I've found that the board it's powered from is only suppling 4 volts.
Running the smoke unit on a 7.2v power supply it works OK.
Is 4 volt the correct voltage?
It's a Taigen Smoke Unit V2.
Thanks for looking
Smoke unit only on 4 volts
-
- Recruit
- Posts: 3
- Joined: Thu May 02, 2024 1:42 pm
Re: Smoke unit only on 4 volts
I'm new to RC tanks, is it possible the voltage increases when moving?
-
- Recruit
- Posts: 3
- Joined: Thu May 02, 2024 1:42 pm
Re: Smoke unit only on 4 volts
Sorry, I can answer my own question, 'yes' the voltage goes up as you drive the tank, but it's not very good. I think I need a mod of some sort
- Herr Dr. Professor
- Lieutenant
- Posts: 3738
- Joined: Mon Apr 22, 2019 10:48 pm
- Location: Southern Wisconsin USA
Re: Smoke unit only on 4 volts
THOverkill: it sure seems as if you know what you are doing, and it's good that you have found the solution. I hope you will check out viewtopic.php?t=23936 and do an introduction.