PDSGB + sabertooth 2x12 rc troubles.
-
- Lance Corporal
- Posts: 125
- Joined: Sat May 22, 2021 1:03 am
PDSGB + sabertooth 2x12 rc troubles.
Is it possible to get a PDSGB gearbox to work with a sabertooth 2x12 rc version? Not the standard version, the RC version.
- tankme
- Warrant Officer 1st Class
- Posts: 2010
- Joined: Tue Oct 31, 2017 3:51 pm
- Location: Elgin, TX
- Contact:
Re: PDSGB + sabertooth 2x12 rc troubles.
Technically the PDSGB is just two motors so the Sabertooth can control two motors. The issue is that one of the motors is used for straight line movement and the other is used for turning. Although the Sabertooth could control each motor, it would not be able to know which one is doing what unless it was connected via an intermediary board like a TCB through the serial connection. The logic telling the ESC which motor does what is built into the control board in the case of the TCB, HL, ASP, Clark, etc. From what I know about the Sabertooth, it has dip switches on it. One of them controls mixing. You could try and turn off mixing, but that might make the control of the motors difficult depending on which channels end up mapping to which stick. If it was on a single stick then I think the tank wouldn't move as turning left or right would do nothing. The turning motor relies on the movement of the big 550 forward/reverse motor to make the turn. Without mixing the single stick option wouldn't work. If you put it on two sticks you could create forward or reverse motor motion and then apply left or right with the other stick. I think that would work, but it might be a little wonky.
Derek
Too many project builds to list...
Too many project builds to list...
Re: PDSGB + sabertooth 2x12 rc troubles.
Also is 12a going to cut it for the 480, 550 combo?
- tankme
- Warrant Officer 1st Class
- Posts: 2010
- Joined: Tue Oct 31, 2017 3:51 pm
- Location: Elgin, TX
- Contact:
Re: PDSGB + sabertooth 2x12 rc troubles.
I would definitely use an inline fuse.
Derek
Too many project builds to list...
Too many project builds to list...
-
- Lance Corporal
- Posts: 125
- Joined: Sat May 22, 2021 1:03 am
Re: PDSGB + sabertooth 2x12 rc troubles.
Thanks tankme, I do have both channels on one stick, I’ll try changing stick mode to tamiya style. This version of the 2x12 doesn’t have serial input because I ordered the wrong one. I did put a fuse on the drive motor lead. The esc has “overcurrent protection” built in supposedly. You think 12a continuous won’t be enough?
- tankme
- Warrant Officer 1st Class
- Posts: 2010
- Joined: Tue Oct 31, 2017 3:51 pm
- Location: Elgin, TX
- Contact:
Re: PDSGB + sabertooth 2x12 rc troubles.
12A may be enough for normal operation, but I always plan for abnormal operation. If a rock or stick gets stuck in a track the motor could pull more than 12A. Overcurrent protection is nice if the abnormal behavior is within the parameters of the ESC. If it isn't then the fuses are there to save the day.
Derek
Too many project builds to list...
Too many project builds to list...